PLL-010: syntesized generator with parallel control
Output in the range 40-2000 MHz @ 7-10 dBm (according with VCO)
PCB dimensions 43x138mm; power 16-20Vdc (according with VCO)
PLL-020: syntesized generator with serial control
Output in the range 40-2000 MHz @ 7-10 dBm (according with VCO)
Minimum step within adjacent channels 10kHz @ 2GHz
PCB dimensions 43x87mm; power 16-20Vdc (according with VCO)
PLL-030: double syntesized generator with serial control
Output 1: in the range 40-2000MHz @ 7-10 dBm (according with VCO)
Output 2: in the range 40-500 MHz @ 7-10 dBm (according with VCO)
PCB dimensions 43x102mm; power 16-20Vdc (according with VCO)
DDS-010: digital syntesis sine-wave generator (serial control)
Output 100kHz-50MHz @ 10 dBm (typical; upper frequencies with decreasing power); minimum step 1Hz or less
Typical spurs and harmonics level -30dB
PCB dimensions 43x87mm; power 12Vdc
RF up to 2000MHz (according with mixer); LO 7dBm typical
Typical IF 900MHz, 450MHz, 70MHz
PCB dimensions 43x87mm; circuit is passive
IFS-010: intermediate frequency strip
Frequency and band selection by helix filter characteristics
Typical gain 28dB (900 MHz), 30dB (450 MHz)
Special models with SAW filter
PCB dimensions 43x87mm; power 12-24Vdc
SRX-010: riceiver with dc O/P proportional to signal in dB (RSSI)
Typical frequency 70 MHz (IF for tracking receivers)
PCB dimensions 43x87mm; power 12Vdc
RLD-010: RF Logarithmic Detector
Mixer input 70 MHz (0/-100dBm dynamic range)
Detector intermediate stage 10.7 MHz (+13/-107dBm dynamic range)
Bandpass selection (-10dB): ceramic (400kHz) or Xtal (12kHz) filters
PCB dimensions 43x102mm; power +12/-12Vdc
SFE-010: tracking receiver front-end
L-band input (segments in 950-2150 MHz range); 70 MHz output
Double conversion (L-band/450 MHZ; 450 MHz/70 MHz)
PCB dimensions 43x102mm; power 12-15Vdc
RFD-010: Radio Frequency Detector
50 Ohm SMA input, frequency up to 2.5 GHz
DC linear output with conversion gain 7.5Vout/Vinrms
Form-C output with adjustable threshold detection
Suitable for RF amplifiers output monitoring (with RF coupler)
Version with diode detector for less critical applications
PCB dimensions 36x51mm; power 12-15Vdc
FLT-010: lumped components (SMT) RF filter
Configuration (LP, HP, BP) and characteristichs according with components values and population
PCB dimensions 18x53mm; circuit is passive